INSTRUMENTATION ENGINEER

Job resposibilities: 

1. Preparation & Review of P&ID diagram
2. Preparation of Datasheets for Field instruments, special instruments, JB, Cables, Trays, Instrument fittings etc.
3. Preparation of Instrument Index, I/O list, cable schedule, Junction box schedule, wiring diagram, termination diagram, Instrument Hook-up drawing, Instrument location drawing, Earthing layouts, Control schematic diagram, logic diagram and Loop diagram, Instrument installation diagram.
4. Preparation of Design basis and Control philosophy for various instrumentation process system and packages/skids
5. Sizing of control valve, Safety valve, flow element such as orifice & annubar. Wake frequency calculations for TW in SPI/Intools/Instrucalc
6. Review and preparation of material requisition/RFQ, vendor offer evaluation, technical bid analysis (TBA).
7. Review of vendor documents such as instrument datasheet, Panel wiring & Panel General Arrangement drawings, Power calculation, Earthing drawings
8. Preparation and review of PLCArchitecture, I/O mapping, review of PLC panel wiring & GA drawings and HMI & SCADA graphics
9. Co-ordination with inter disciplines such as Electrical, Mechanical, Process and Civil for instrumentation interfaces.
10. Co-ordination with external stakeholders such as vendors, clients & consultant
11. Knowledge in review of quality inspection, QA documents, FAT/SAT procedures.
12. Exposure on review of instrumentation system in 3D model software 

Extra Low Voltage system (ELV)

1. Knowledge about design codes & standards such as NBC, Fire alarm system such as IS 2189, NFPA 72 & BS 5839
2. Design of Fire alarm system as per NBC, NFA, & IS standards
3. Design of Public address system, CCTV surveillance, Telephone (EPABX) & LAN system and Access control system 
4. Design knowledge in Building Management System (BMS)
5. nterfacing of all the above systems and preparing Interfacing matrix
6. Exposure on review of ELV system modelling & review in 3D model software